EcuTeK and its tuners around the world are constantly working to improve the benefits of a reflash / tune of your cars ECU.
Visit us on Facebook or the MRT Performance web site to see just some of the Dyno Graphs that we have uploaded for you to review.

A few points:

Please don't compare an EcuTeK retuned ECU (or MRT power parts) to other performance options by power and torque figures only.
Often a dyno graph only tells half the story.
Dyno results are effected by many things:

The ability for the engine package to "flow" such as good airfilter, intercooler, head design, turbo catalytic converter and exhaust.
The turbo to maintain boost as the engine rpm increases. (remember as RPM climbs so does the demand of the turbo to "keep up with the boost and air flow")
 An intercooler that can keep the inlet charge low
 Good ignition timing
Also remember some dyno tuners don't have the ability to keep inlet air charge constant, especially with regard to intercooling. MRT has two dedicated blower fans, one for radiator and or Front mount intercooler and a separate one to supply volumes of air to the Top Mount Intercooler with a dedicated duct. (see pics)

Some dyno cells simply don't flow enough air across the bonnet to allow constant repeatable power runs, and this causes the Top mounted Intercooler simply to heat soak and over heat and this can increase inlet temps! For handy web data on the Metric system of units refer here http://www.simetric.co.uk/sibasis.htm

TORQUE

Take for example the Subaru B4 Twin Turbo, depending on the dyno its tested on will have a large impact on the mid range turbo change over point. On a rolling road where the inertia is high, (such as A dyno dynamics Dyno http://www.dyno.com.au/) the Torque and power dip is shown to be much less, however on a hub type Dyno Such as the Dyna pack the dip looks worse. This is because the Hub dyno is more repeatable and responds faster to torque and power change than a rolling road dyno. (the reciprocating parts and their mass are less)

Based on this the B4 dyno plots on the MRT Dynapack Dyno shows a huge dip on high power B4's, however when you drive the car this is almost impossible to feel.

Another important point is rolling road dyno's can not measure real "Torque" as measured in Nm, they work on "tractive effort" A hub dyno will also show torque at the wheels. (to get Flywheel torque simply divide the figure by the final drive ratio, often a number close to 4)

POWER

Often displayed in Kw, or HP, or in Japan in PS.
Don't be fooled by big power numbers high in the RPM range
Some people like peaky high power cars.
But a TRUE fast car will have high Torque and a Torque curve that is very flat.
Also a car that has an early high power figure may suffer power loss due to a drop in boost, a restriction in the air flow, like turbo, poor exhaust design, or bad airfilter or small catalytic converter.

WHAT TO LOOK FOR

A graph that shows the power and torque climbing early, but not too steep as it may be sensitive to throttle inputs.
A flat torque curve.
A power curve that is nice and linear and not with huge peaks and troughs.

If a pre and post dyno plot to compare before and after is also handy.